Carl 3-D Manuale Utente Scaricare il pdf (Pagina 10)

10

Glue the joiner wire in place with

epoxy. Make sure the elevators are

lying on a flat surface so both will

be parallel. Use a straight edge to

make sure the leading edge is

straight and the tips are at the prop-

er width.

Fit the elevators in place on the CA

hinges.

Deflect the elevator to full travel

and glue hinges with two drops of

thin CA on each hinge. Turn over and

repeat on bottom side.

Fit the rudder in place on the fin and

mark the location of the elevator

wire.

elevator wire

Go to the bottom of the rudder and

mark the location of the tail wheel

tiller arm.

tail wheel

tiller arm

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Commenti su questo manuale

Nessun commento